Tension Rods
1. Measure Opening; Add 1/2"
2. Extend Rod to Proper Width
A. Twist
B.Loosen screw; adjust. Tighten screw.
3. Put up Rod
Pocket must be 1" or more. *Hold rod vertically; slip on panel. Put one end in place. Compress and put other end in place.
May be used with Rings. Must buy separately.
__________________________________________________________________________________
1. Measure Opening; Add 1/2"
2. Prepare Rod
Lay rod face down. Slip retainers(lip down) and spring in large rod section: butt to small. Insert screws but don't tighten. Slip in end caps: "OUT" cap goes in large section. Slip on pads. Extend rod. Hold retainers firmly in place. Tighten screws.
3. Put up Rod (2 people if over 36").
Pocket must be 3" or more. *Hold rod vertically; slip on panel. Put one end in place. Compress gently and put other end in place.
.
